IS200VVIBH1C

Overview

• Part Number: IS200VVIBH1C
• Manufacturer: General Electric
• Product Type: Vibration Monitor Board
• Series: Mark VI

Features

• Probe Compatibility:
  • Proximity
  • Velocity
  • Acceleration
  • Seismic
  • Phase
• Signal Processing:
  • Supports up to 14 probes directly connected
  • A/D conversion of vibration signals
  • Transmits processed signals to controller via VME bus
• Power Supply:
  • Provides -28 V DC for Proximitor power
  • Excitation sources: -23 to -26 V DC, short-circuit protected
• Sampling Rate:
  • Up to 4,600 samples per second
  • Peak-to-peak voltage scaled for engineering units (EU)
• Redundancy:
  • TMR mode with diode high-select circuit for -28 V DC bus

Installation Instructions

• Power off the VME processor rack.
• Insert the board's edge connectors and secure with top and bottom levers.
• Tighten the captive screws on the front panel.

Operation

• Supported Probes:
  • Bently Nevada Proximitor, Seismic, Accelerometer, Velomitor
• Signal Transmission:
  • Digitized signals sent to the controller over the VME bus
  • Supports simplex or TMR mode for redundancy

Physical Specifications

• Faceplate: Single-slot, with LED indicators (run/fail/status)
• Connectors:
  • P1 and P2 backplane connectors
  • Four additional connectors on the board

Components

• Integrated Circuits:
  • FPGAs, RAM, SRAM chips
• Board Components:
  • Resistors, diodes, capacitors, inductors (also on back surface)

---