PM5100

Configured for electrical energy measurement and power quality monitoring in PowerLogic PM5000 platforms, the Schneider Electric METSEPM5100 (PM5100 Power Meter) provides direct measurement of voltage, current, frequency, power factor, active/reactive power, energy values, and harmonic components up to the 15th order.

Hardware Specifications

Parameter	Specification
Model	METSEPM5100
Brand	Schneider Electric
Product Series	PowerLogic PM5000
Product Type	Power Meter
Weight	380 g
Dimensions	96 mm W x 72 mm D x 96 mm H
Operating Temp	-25 to 70 deg C (meter); -20 to 70 deg C (display)
Power Consumption	11 VA maximum at 415 VAC
Display Type	Monochrome graphic LCD, 128 x 128 pixels
Mounting Mode	Flush-mounted
Rated Supply Voltage	90 to 450 VAC, 45 to 65 Hz; 100 to 300 VDC
Rated Current Input	1 A or 5 A
Network Configuration	1P + N, 3P, 3P + N
Measurement Voltage	35 to 760 VAC between phases; 20 to 400 VAC between phase and neutral
Frequency Range	45 to 65 Hz
Sampling Rate	64 samples/cycle
Harmonic Measurement	Up to 15th harmonic
Accuracy Class	Class 0.5S active energy according to IEC 62053-22
Pulse Output	1 energy pulse output
Alarm Function	33 configurable alarms
Protection Rating	IP54 front display, IP30 rear enclosure
Certifications	CE, cULus

Deterministic Network and Power Measurement Characteristics

The METSEPM5100 integrates electrical acquisition circuits for three-phase and single-phase power monitoring. The measurement engine processes voltage and current input signals with 64 samples per cycle and calculates active power, reactive power, apparent power, energy, frequency, and power factor values.

The meter supports power quality analysis through harmonic measurement up to the 15th harmonic component. Measurement accuracy is defined by IEC 62053-22 Class 0.5S requirements for active energy.

The device includes a pulse output channel for remote energy accumulation and provides configurable alarm handling with 33 alarm conditions. Recorded data includes minimum and maximum instantaneous values with time stamping functions.

Frequently Asked Questions

Q: What current input signals are supported by the METSEPM5100?
A: The meter accepts line current inputs rated at 1 A or 5 A for current transformer measurement circuits.

Q: Does the METSEPM5100 provide serial communication ports?
A: The METSEPM5100 model provides pulse output communication only. No communication protocol is assigned for the communication port.

Q: What mounting method is required for installation?
A: The meter is installed using a flush-mounted configuration with a framework mounting support.

Field Installation Guidelines

Install the METSEPM5100 in a panel cutout suitable for the 96 mm x 96 mm front display format. Connect voltage sensing circuits, current transformer inputs, and pulse output wiring according to the terminal assignment documentation.

Current transformer secondary wiring should maintain correct polarity and avoid open-circuit operation during commissioning. Separate measurement wiring from high-voltage switching conductors where possible to reduce electrical interference.

Protect signal wiring with proper grounding and shielding practices according to the installation environment. Verify phase sequence, network configuration, and rated input settings before energizing the meter.

---