ASHDTA200

The Schneider Electric ASHDTA200, also cataloged as the ASHDTA200 terminal connection module, provides a field wiring interface for Schneider Electric PAC and PLC I/O assemblies. The unit uses a high-density multi-pin connection interface and DIN rail mounting for signal routing between field wiring and the control system.

Hardware Specifications

Parameter	Specification
Model	ASHDTA200
Brand	Schneider Electric
Product Type	PAC / PLC Connection Terminal Module
Series	TSX Compact
Module Function	Terminal connection and signal distribution
Mounting	Standard DIN rail
Connection Interface	Multi-pin terminal block / high-density connector interface
Enclosure / Protection	IP20
Operating Temp	-25 deg C to +70 deg C
Weight	0.44 lb
Standards	CE, RoHS, UL listed
Subrack Configuration	5-slot TSX Compact
Application	PLC I/O wiring, signal routing, control panel connection

Schneider Electric I/O Interface and Density

The ASHDTA200 is associated with the TSX Compact 5-slot subrack configuration. Its high-density connection interface provides a defined wiring point between field conductors and the PLC I/O assembly. DIN rail mounting fixes the connection hardware within the control cabinet while the IP20 construction is intended for enclosed panel installation.

For installation, the connector arrangement should be matched to the corresponding TSX Compact assembly and wiring documentation. Signal conductors should be separated from high-energy power wiring where practical to limit conducted and induced interference.

Frequently Asked Questions

Q: What mounting method is specified for the ASHDTA200?
A: The supplied data specifies standard DIN rail mounting.

Q: What environmental temperature range is specified?
A: The supplied specification gives an operating range of -25 deg C to +70 deg C.

Q: Is the ASHDTA200 suitable for exposed outdoor installation?
A: No outdoor suitability is specified. Its IP20 rating indicates use inside a protected control cabinet or enclosure.

Field Installation Guidelines

Install the ASHDTA200 on the specified DIN rail and verify mechanical engagement before connecting field wiring. Confirm connector orientation and terminal identification against the applicable Schneider Electric wiring documentation.

Route signal wiring separately from AC power, motor, and other high-current conductors where possible. Maintain the specified protective-earth and cabinet grounding arrangement. Cable shields should be terminated according to the system wiring specification rather than connected arbitrarily at the terminal module.

Before energizing the PLC assembly, verify terminal polarity, conductor identification, connector seating, and continuity. Do not apply field voltage to terminals whose electrical function has not been confirmed from the applicable system documentation.

---