ABFTE20EP200

Configured for discrete input signal connection between Modicon PLCs and Telefast ABE7 sub-bases, the Schneider Electric ABFTE20EP200 (ABFTE20EP200 connecting cable) provides direct pre-wired interconnection through 20-way HE10 connectors. The cable length is 2 m, with 28 AWG conductors and 0.08 mm2 cross-sectional area.

Hardware Specifications

Parameter	Specification
Model	ABFTE20EP200
Brand	Schneider Electric
Product Range	Modicon ABE7 / Twido
Product Type	Discrete input pre-formed connecting cable
Application	PLC-to-connection-sub-base discrete input wiring
Connector, Sensor Side	20-way HE10
Connector, PLC Side	20-way HE10
Cable Length	2 m
Conductor Gauge	28 AWG
Cable Cross Section	0.08 mm2
Number of Channels	16-channel connection
Net Weight	0.14 kg
Origin	Thailand
Package Quantity	1 PCE
Compatible PLCs	Modicon M221, Twido
Compatible Modules	TM3DI16K, TM3DI32K, TWDDDI16DK, TWDDDI32DK
Operating Temp	Not specified in supplied data
Power Consumption	Passive cable; no separate power consumption specified
Dimensions	Cable length 2 m; overall cable dimensions not specified

Pre-Wired I/O Connection and Backplane Compatibility

The ABFTE20EP200 provides a pre-formed connection between discrete input circuitry and compatible Modicon control hardware. Its two 20-way HE10 connectors provide direct mating interfaces on the sensor and PLC sides.

The cable supports connection to passive and relay ABE7 sub-bases with 16-channel configurations. It also supports specified Modicon M221, Twido, and TM3 discrete input hardware.

The cable itself does not provide protocol conversion or active signal conditioning. Signal adaptation, common-polarity distribution, and channel interfacing depend on the connected Telefast ABE7 sub-base configuration.

Frequently Asked Questions (FAQ)

Q: What connectors are installed on the ABFTE20EP200?
A: The cable has one 20-way HE10 connector on the sensor side and one 20-way HE10 connector on the Twido or PLC side.

Q: What is the electrical conductor size?
A: The cable uses 28 AWG conductors with a specified cross-sectional area of 0.08 mm2.

Q: Does the cable require an independent power supply?
A: No independent power consumption is specified because the ABFTE20EP200 is a passive pre-formed connecting cable.

Field Installation Guidelines

• Verify the HE10 connector keying and pin assignment before mating either cable end.
• Confirm that the connected PLC or I/O module appears in the specified compatibility list.
• Route the cable separately from high-voltage power conductors and high-current switching circuits.
• Avoid excessive bending, tensile loading, crushing, or mechanical stress at both HE10 connectors.
• Maintain appropriate separation from motor cables and other high-noise conductors.
• Where shielded installation practices apply, terminate cable shielding according to the connected system documentation.
• Verify discrete input polarity and common connections at the associated ABE7 sub-base before energization.
• Perform continuity and point-to-point verification before applying operating power.

---