467NHP81100

Configured for Profibus DP network interfacing in Modicon Quantum communication modules, the Schneider Electric 467NHP81100 (467NHP81100 PCMCIA Card) provides direct physical/electrical execution. It serves as a removable hardware extension designed for seamless installation into host communication cards such as the 140CRP81100 to enable high-speed fieldbus access.

Hardware Specifications

Parameter	Specification
Model	467NHP81100
Brand	Schneider Electric
Origin	France
Weight	291.0 g
Dimensions	17.000 cm x 15.500 cm x 3.500 cm
Operating Temp	0 to +60 deg C
Power Consumption	Powered via host slot backplane
Product Compatibility	Modicon Quantum 140CRP81100 module
Communication Port Protocol	Profibus DP
Accessory / Part Type	PCMCIA Card
Network Speed	Up to 12 Mbps (Profibus DP standard)

Industrial Control & Drive Communication Architecture

The 467NHP81100 utilizes specialized interface circuitry to handle Profibus DP deterministic networks without taxing the primary module CPU. Data frames are transferred directly across the host module interface via dedicated backplane bus communication velocity channels, minimizing transfer latencies. Electrostatic discharge protection circuits on the card interface isolate the module's core logic from electrical transients typical in industrial fieldbus wiring environments. Proper insertion ensures solid coupling with the internal connector to maintain firmware flash compatibility and error-free network packet execution.

Frequently Asked Questions

Q: Can the 467NHP81100 PCMCIA card be hot-swapped while the host module is powered?

A: No, inserting or removing the card during live operation can cause hardware fault states on the host 140CRP81100 communication module or disrupt network transmission. Power off the host rack before installation or removal.

Q: Is this PCMCIA card supported by all Modicon Quantum communication modules?

A: No, the 467NHP81100 is specifically designed and certified for use with the Schneider Electric 140CRP81100 Profibus DP host communication module.

Field Installation Guidelines

1. Ensure the power supply to the host Modicon Quantum rack is completely switched off before proceeding with installation.
2. Ground yourself using an ESD wrist strap connected to an unpainted metal surface on the enclosure rack.
3. Locate the PCMCIA slot on the front or side face of the 140CRP81100 host module.
4. Align the 467NHP81100 card firmly with the internal connector guide rails. Push until the card seats fully and the mechanical ejector pin engages.
5. Verify shield ground continuity on the connected Profibus DP fieldbus network cable to prevent EMI interference on high-baud lines.
6. Re-energize the Quantum rack power supply and check the host module diagnostic LEDs to confirm module communication initialization.

---